三星S5PV210启动选项是：
1. OneNAND boot:
- Xm0CSn4/NFCSn2/ONANDXL_CSn0 signal should be used for boot.
- iROM code check a checksum data.
(BL1 code must include a checksum data. If BL1 code is loaded into internal SRAM. iROM code will compare a
checksum data made by iROM with loaded one. Loading address is 0xD0020008.)
- OneNand clock is 33MHz using MPLL(667MHz) for boot
2. NAND boot:
- Using H/W 8bit ECC at boot page
- V210 supports 16bit ECC in case of 4KB, 5cycle Nand type.
- V210 supports 4bit ECC in case of 2KB, 5cycle 16-bit bus Nand type.
- iROM code check a checksum data.
- Xm0CSn2/NFCSn0 signal should be used for boot
3. SD/MMC and eMMC boot:
- First boot is using SDMMC CH0 as 4bit.
- Second boot is using SDMMC CH2 as 4bit.
- iROM code check a checksum data.
- SD/MMC clock is 20MHz using EPLL for boot
(BL1 code must include a checksum data. If BL1 code is loaded into internal SRAM. iROM code will compare a
checksum data made by iROM with loaded one. Loading address is 0xD0020008.)
4. eMMC boot
- SDMMC CH0 can be used for eMMC boot(4/8 bit). Bus width is controlled by OM setting
- iROM code check a checksum data.
(BL1 code must include a checksum data. If BL1 code is loaded into internal SRAM. iROM code will compare a
checksum data made by iROM with loaded one. Loading address is 0xD0020008.)
- SD/MMC clock is 20MHz using EPLL for boot

在SMDKV210.BAT里：
set BSP_NOSDMMC_BOOT=
if /i "%BSP_NOSDMMC_BOOT%"=="" set BSP_NONANDFS=1
编译通过了，烧写工具用6410的IROM_Fusing_Tool_SDHC.exe。烧写前都先格式化TF卡为FAT32格式的，烧写stepldr.nb0后把eboot.nb0，bootimage.nb0，nk.bin等文件都拷贝到TF卡上。烧写stepldr.nb0成功后的截图如下：（我只选择IMAGE文件和SD驱动号G，其他没选，这样是否正确呀？）